Contact Us

Stock that Ships in 48 Hours

200P6PROV 2" Poly Pump with 6.5 HP Briggs FKM (Viton type) Stratton Pro Series, FKM/316 SS Seal

SKU: BAN-200P6PROV
  • Part Number:
    BAN-200P6PROV
  • Capacity:
    6.5 Horsepower
  • Dimensions:
    2"
  • Availability:
    In Stock
  • Ships From:
    IN
$ 1,255 09

*Stock subject to change. Please call to confirm.

2" Poly Pump 6.5HP B&S Pro Eng - FKM

Motor Features

* Cast iron cylinder sleeve.
* Heavy duty flywheel.
* Overhead valve.
* High oil fill
* Oil Guard low oil sensor.
* Breather through air cleaner

# PUMP FEATURES: Precision molded construction
# Corrosion resistant.
# Low maintenance
# Superior design.
# Lightweight
# EPDM Standard, FKM (viton type) available.
Maximum Engine Protection!

We have designed the new Banjo poly pump to protect the engine seal in the event of pump seal failure. We have separated the pump from the engine installed a special slinger/engine seal that completely protects the enginefrom any corrosive fluids. This new slinger design is the best in the poly pump industry at protecting your engine.

For additional seal protection, small vanes are molded into the backside of the impeller. During operation, these vanes (on backside of the impeller) pump out a major portion of the liquid from the seal area which reduces pressure. The internal operating pressure of the pump is approximately 50 P.S.I. with the seal area operating at only 5 P.S.I. This leaves enough liquid in the seal area to lubricate and cool.

Priming is now made easier by the incorporation of two new prime and drain plugs. These plugs are now made to act as thumb screws with o-ring seals for quick priming and draining before and after use. Priming is from the bottom of the pump chamber. A very small amount of liquid in the bottom of the pump is sufficient for priming since the liquid enters the volute from the bottom side. The pump will prime with the check valveopen.

The impeller has been designed for easy removal during maintenance. A 7/16" 14 hex nut is installed into the impeller during assembly at our plant. This nut is used to lift the impeller from the engine shaft by screwing a 7/16" 14 bolt into nut at the end of the impeller.

CAUTION-WARNING: Please do not run pump dry, restrict or reduce port sizes, or dead head pump. This could cause component failure to pump.
DO NOT USE WITH FfLAMMABLE LIQUIDs.

NOTE: Engine warranty service available at authorized Briggs & Stratton and Honda dealers.
  • SKU
    BAN-200P6PROV
  • Part Number
    BAN-200P6PROV
  • Capacity (Gallons) 6.5 Horsepower
  • Dimensions 2"
  • Weight (lbs) 45
  • Manufacturer
    Banjo
  • Availability In Stock
  • Shipping From IN
  • Freight Class 70
  • Shipping Length 20
  • Shipping Width 14
  • Shipping Height 16
  • Shipping Weight (lbs) 45